DescriptionAnchor Safe Lift Truck matBi-level surface effectively removes moisture and dirt from lift truck wheels to improve lift truck safetyModular mats are easy to install and scalable for the applicationAggresive adhesive taping system keeps tiles from movingPolypropylene carpet is easy to clean and fast dryingDurable rubber backing and polypropylene carpet top withstands lift truck traffic up to 14,000 lbsRecommended for all buildings where lift trucks must enter and exit a building to and from the outsideSURFACE Fiber Type: Solution Dyed Polypropylene (Recycled PET Fiber) Backing Type: SBR Rubber Weight: 5 kg/m² Thickness: 8,6 mm Size: 115×180 Moisture Barrier Polyester FilmBACKING Material: SBR rubber – smooth Thickness: 100-milSTANDARDS & TESTINGPasses Flammability Standard DOC-FF-1-70Conforms fire retardancy test EN 13501-1 (2007) A1 (2009)Cleaning InstructionsWaterHog Forklift mats can be cleaned using the following instructions:Vacuum regularly (daily in high-traffic commercial areas; weekly in lower-traffic areas)Extract or hose off as needed to remove heavy soil/debrisHang mat to dryAlways make sure the mat is dry before placing it back in service. Installation InstructionsPlace the mat face down with the rubber backing side up.Place double-sided tape (sold separately) along all four sides of the tile, as close to the edge as possible. The sticky side goes on the rubber with the blue side facing up.Add more tape inside the rectangle. Create an X by placing tape from one corner diagonally to the opposite corner.(Note: 1 roll of double-sided tape will cover 3 WaterHog Forklift tiles)Place the tile in the desired position. Carefully fold one half of the tile back, exposing the blue tape.Remove the blue liner and trim back to the folded area. Then fold that half back into place and repeat on the other side.To secure the bond between the tape and the tile, apply pressure by walking around each side of the tile. Browse our full range of Entrance Mattings here
